It’s a common story for anyone who’s ever bought a used car to have the dreaded “check engine light” and find that it’s not lit.
It’s not a good sign, as it indicates the engine is not running correctly.
It can happen when the engine overheats and the car has trouble starting.
But if you’re an aspiring car designer, you can fix the problem with a simple DIY solution: Install a new engine.
This involves removing the old one and replacing it with a brand new one.
To start, you’ll need a tool that can cut a hole in the stock engine bay and bolt in a new one with the proper tools.
Then, just follow these simple steps: Put some duct tape on the new engine bay.
It should look something like this: It’s called a carpenter’s tape, and it’s the easiest way to make a hole.
Once you’ve done that, you should have a new gas tank and the fuel cap, which will hold the old engine in place.
You can even do it by putting a small piece of plywood over the top of the old tank.
It works great to seal the new tank, since the new one won’t leak.
Make sure you have a good seal on the inside of the engine bay, too.
This will protect your car from any possible engine damage.
Next, attach the old gas tank.
You’ll want to secure the hose to the fuel tank.
Then connect the hose from the old fuel tank to the new gas one, and tighten it all the way.
You should now have a nice, tight seal that will keep your car running.
Once the engine has been bolted in place, it’s time to put it back together.
This is where things get a little tricky.
First, make sure you remove the engine and all the hardware you need.
Then pull the new fuel tank out and attach the hose.
It will look something similar to this: If you don’t have a big, solid piece of wood to block the hose, just pull it with your bare hands.
Once it’s in place and tight, just attach the fuel hose to your new fuel car.
You won’t have to worry about pulling it apart, as the car will now be fully functional.
Now it’s up to you to attach the new gear box.
This part is a little more tricky, but if you follow these steps, you won’t be disappointed.
The gear box will look like this once the fuel line is in place: Now the gear box needs to be bolted to the car.
This process is just like the old-fashioned method.
The main difference is that you’ll have to put some kind of fastener on the fuel side of the gearbox to hold it in place as it is bolted to your car.
Once your car is ready, you need to put the gear back together, too: The new gearbox should look like a stock engine.
You may notice the new exhaust and the new wheels in the photo above.
You just replaced the old wheels with the new ones, too, since they’ll be easier to clean.
This new gear has two small holes in the side of it.
The hole in which you attach the gear will hold everything in place when the new car is fitted with the engine.
But don’t worry, it won’t get in the way of the car’s performance, as long as you don and keep your fingers off the gear.
The old gear is already in place so you can put it in your garage and put it to good use.
Next up, put your car in the shop.
It’ll be time to start assembling your new engine and getting it back to life.